 |
To
restore the original (source) file(s) out of the
created archives you first have to specify their
location. You see in section (1) three
symbols representing disk A, disk B and other
drives. A click at one of these symbols opens the
"select-file-dialog" of the selected
drive..
This "select-file-dialog" shows a file,
normally named "packager.001"; it is
the first archive. You have to click at this
archive and then click at the button open. |
The next thing to do is to choose the
target directory for the original (source) file(s) by
clicking at the symbol "target". (2)
In the section below a summary of your input is
shown. You can now proceed by clicking button (3)
and a new screen appears.Here you can see in the
upper section a listing of the included file(s). Below
you can see the state of restoration. If a floppy disk is
your source, insert disk 1 when the request to do so
appears on the screen. In the case you've chosen a hard
disk as source, this step is obsolete. Now you can start
the restoration through a click at the "GO"
button! After the restoration is finished, a new window
appears.
design
& concept by arclab / copyright 1999 arclab software
GdbR
all brand
names and trademarks are the property of their respective
owners
|
